High Accuracy Weighing Sensor 500kg 200kg 100kg 50kg Load Cell Transducer
High accuracy Weighing Sensor FNN is a strain gauge based weight transducer which offers 0-60kg / 0-100kg / 0-200kg / 0-350kg / 0-500kg five measuring ranges to choose from.High accuracy weight sensor FNN delivers maximum 0.015% non-linearity of the full capacity. Loadcell FNL is corner trimmed for platform sizes up to 400x500mm which makes it suitable for off-center load measurement. Load Cell sensor FNN delivers stable performance within the declared working temperature range thanks to its temperature compensation process. You may find Load cell transducer FNN suitable for applications such as beehive weighing scales, packing machines, platform scales, feeding machines and so on.
60kg / 600N / 132lb
100kg / 1000N / 220lb
200kg / 2000N / 440lb
350kg / 3500N / 770lb
500kg / 5000N / 1100lb
||Temperature shift zero
||Temperature shift span
||Material of element
||Ø5*1500mm 4-core shielded
Red--Power input+ Black--Power input-
Green--Signal output+ White--Signal output-
A weight sensor is a transducer that converts mechanical load into electrical signal which is proportional to the load being applied.The measured load or force causes deformation of the measuring element(elastic body),the bonded strain gauge deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply, the output signal between Sig+ and Sig- will change proportionally, thus the load/force can be measured by measuring the output signal from the load cell which is normally within 0-30mV for off center load cell FNN. Overloading is the most common cause of loadcell failure, a load sensor is just like a spring in certain aspects, which will be damaged if overstretched or overloaded. A machanical stop(refer to below picture) can be used to protect the sensor from excessive deformation. The deformation distance can be determined by loading the sensor with rated capacity, then adjust the meachnical stop to reach the bottom of the transducer. In most cases, the load cell will be used to measure load at 40-80% of the full capacity, thus the deformation distance can be adjusted using reference load a bit higher than the target load to be measured instead of the rated capacity.
High Accuracy Weighing Transducer 500kg 300kg 200kg 100kg 50kg Loadcell Sensor
Click here to download datasheet